binder content

New Method to Calculate Initial Asphalt Binder Content for Stone Matrix Asphalt

沥青玛蹄脂碎石初始沥青用量的计算方法

The propagation rate of crack also decreases with increasing the binder content of cermets.

随着金属陶瓷中金属相含量的增加,裂纹扩展速率降低.

Experimental results indicate that the optimized binder content and ingoing temperature of airflow are 50 ml/ kg and 240 ℃, respectively.

SiC粉体在喷雾造粒时最佳粘合剂含量和进口热风温度分别为50ml/kg和240℃。

Using the blend of epoxy resin and phenolic resin as binder, whose functional group molar ratio was 1:3, and the total resin content was 17wt%.

粘结剂使用EP和PF的共混树脂，其官能团摩尔比为1：3，总树脂含量为17wt%。

Different body molding pressure, optimal value ceramic binder content is different.

不同的坯体成型压力下，陶瓷粘结剂含量最优值是不同。

The extent to the effect of types and content of mineral admixtures on ARH reduction of concrete resulting from self-desiccation can be reflected by the parameter of the effective water to binder ratio r_e effectively.

有效水胶比re可有效地反映不同龄期下矿物掺和料种类和掺量等变量对混凝土自干燥效应的影响程度。

SiC powders were treated by spray pelletization, and the influences of processing conditions and binder content on the crushing behavior of SiC granule during compaction were investigated.

采用压力喷雾造粒的方式对SiC粉体进行喷雾造粒处理，研究了喷雾造粒过程中工艺条件和浆料中粘合剂含量对成型过程中粉料颗粒破碎行为的影响。

The experimental results showed that the bonding performance of the soil binder was related to its gel SiO_2 content and structure of the noncrystalline phase.

结果表明：土壤粘合剂粘结性能与SiO2溶胶数量及结构性能有关。

Relationship between resin binder content and properties of automotive friction materials

树脂粘结剂含量对汽车摩擦材料性能的影响

The low content of clay is the main reason that the performance of the soil stabilized with inorganic binder is poor.

研究认为，粘粒含量低是无机结和料稳定该类土性能差的主要原因。

The effect of the binder content and the second activat temperature on properties of activated carbons in pellet such as the compressive streng bulk density and gasoline adsorption were investigated.

考察了黏结剂添加量和二次活化温度对成型活性炭强度、堆积密度、油气吸附性能等影响。

It was shown that, complex figure W-skeleton with homogeneous porosity distribution can be obtained with 35% ( in volume) binder content and high temperature.

结果表明，添加35%体积分数的粘结剂并在压制过程中提高压制温度会明显改善钨骨架孔隙度分布的均匀性；